Honda D Series Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Going to do a mini-me over the winter, i have a D15B7 block in good condition, a D16y8 head ready to swap on. I have a obx D16Z6 cam too. Where i'm stuck is timing it up!

So, does anyone out there know what belt and cam gear to use with a B7 block, y8 head, and z6 cam?!

I'm kinda stuck with this configuration, i'm in the uk and d-series parts are hard to come by. But i do have access to 97 octane fuel, so i'm thinking a high compression build! How much should i mill the head with this in mind? If this setup can even be made to work!!
 
1 - 3 of 3 Posts
Top