Honda D Series Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
the front side rails of my car currently sit at 19cm and the rear sits at 22cm

my question is whats the best ratio for road racing ( handling) and what would be the best ratio for drag racing? (strait line/launch)
Wood Composite material Gas Metal Window
Wood Automotive tire Tire Bumper Gas
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #4 ·
For autocross, these cars like to be level or be very slightly higher in the rear (like 1/8”). Cars in my class run fairly low at about 4” from the jack points, and they tend to have trouble with front grip if the rear is any lower than the front. Too much rake, and they’re unstable at higher speeds. Of course, it also depends on suspension mods.
is having my rear end 3cm taller than the front hurting me in the corners ?
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #6 · (Edited)
This depends a lot on other suspension settings, spring rates, caster, and even how much power you put to the ground.
24 inch gsr front sway bar in the front , no sway bar in the back, 12k spring rate front , 8k back , stock caster no traction bars, 216whp/159tq, car weights 1780lb, front 3 point strut bar, rear strut bar
225/50/15 front and back for road racing and 225/50/15 front and 22.5/4.5-15 rear for drag racing ( the ratio front to rear changes to 19mm front 20.1mm back )
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #9 ·
Those spring rates are going to want to be pretty close to dead level front to rear with the power you have on tap, might want to try one session with the sway bar disconnected as well.
the car is terrible with no sway bar, drove it for years with no sway bar and its like a pogo stick in the corners
 
1 - 5 of 5 Posts
Top