Honda D Series Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,130 Posts
Discussion Starter #1
I ran a compression test to see how the motor is doing before i boost it and i got 100-140-120-145. Im going to do a full fjt bottom end kit.
 

·
Registered
Joined
·
1,211 Posts
damm....

i just did one today...185-190 across the board, not bad for 244k miles :)
 

·
Registered
Joined
·
1,130 Posts
Discussion Starter #3
i have 113k and its almost 11 years old so time for a boost rebuild
 

·
Registered
Joined
·
956 Posts
I just did mine yesterday cause I had my car dyno and it only put down 115whp when it was 125whp last year. My numbers were 160psi across. I think its also best to do a leak down test too.
 

·
Registered
95 ex coupe
Joined
·
4,281 Posts
how long has it been boosted? and was it good when it was NA? just wondering cause a buddy has low compression and its boosted and we are just kinda waitin for it to blow haha
 

·
Premium Member
Joined
·
760 Posts
Run some restore through it a couple times and do another test. I had one cylinder reading lower then the rest by about 40psi at one time, I reved the shit out of it for a while and took another reading and all where dead even pressure =D Stupid stuck ring.
 
1 - 6 of 6 Posts
Top