Honda D Series Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,402 Posts
Discussion Starter #1
Sorry for this being such an application specific question, but I'll ask anyways to see if anybody spots any immediate problems with this combination.
I'm planning on building a high comp y7 with:
y7 block
d15b7 (PM3) pistons
y7 head milled .030"
~stage 2 cam 272 duration

The compression calculator says I'll be at about 11.8:1 cr.
If the answer is just to clay the motor, how is this done. It'd be best if there was some way to know if this combination would work/not work before I go collecting all the parts.
Thanks.

-ic
 
1 - 2 of 2 Posts
Top