M
Markis.
·Guest
Joined
·
0 Posts
I was wondering if i could use a 98 D16Y8 Intake manifold on a 2000 D16Y8 head
98 Y8 Intake mani on a 00 Y8 Head?
1 - 6 of 6 Posts
Joined
·
2,743 Posts
it will work, you'll just have to disconnect the air injection crap on your 2000 :honda:
Joined
·
2,743 Posts
it's all good man, I only know this cause i had some issues with it about a month ago...lolhondajosh said:
1 - 6 of 6 Posts
Join the discussion
Recommended Reading
-
Oil Pressure dips at 6800rpm
General TechHey guys. D16z6 turbo biild. Brand new ACL Race oil pump. The pressure is dropping right around 6800 rpm. Enough that it looks like its dropping out of vtec. Thoughts??- 10
- 123
-
hot94hatch · updated
-
1998 Civic confusing revving problem
General TechSo my civic has been acting up a lot recently First it was I had the map and tps switched and fixed that easy but my problem still is occurring. When I start my car it starts just fine but when I rev it, it will rev fine 1 or 2 times. after that it will rev cut out, jump 500rpm from where it cut...- 7
- 86
-
which throttle body gasket for intake swap?
General Techi have a d14a4 with a d15z6 im on. i want to swap the throttle body from the 1.4 back on, which throttle body gasket should i use? 1.5 or 1.4?- 2
- 47
-
New to turbo/building. D16y8 question.
General TechHey guys so I’m completely new to this turbo and building stuff lol. Mind you I’ve been working on cars for over 15yrs but strictly all stock and fixing my customers cars. I run an auto repair shop and I finally want to build a motor/ “faster” car. I have a 2000 civic with a d16y8 in it already...- 4
- 142
-
Juanb942 · updated
-
car dies when it warms up
General Techhi, i have an ej9 with a d14a4 and d15z6 manifold. i've had this manifold for a month and the car has been running fine. i left the car for one week, and yesterday started it up and took it for a spin (before the needle got right in the middle, at operating temperature), after i took it for a...- 20
- 355
Join now to ask and comment!