Honda D Series Forum banner

1 - 6 of 6 Posts

·
Registered
EF9 DC2
Joined
·
176 Posts
Discussion Starter #1
Bought these last winter or the winter before. Its on ebay. This same fellow makes a drink holder where the ash tray is on the EF's great idea. Open and bottom has a cradle that drops down, close it and it folds back. 25.00
Back to the letters you get 2 sets white and gray and si in red and black. Under 10.00.
This garnish (think thats what its called) was about free, had white house paint on it and scuffs all over. Wet sand and buffed taped off where the letters go and marked each with a pencil. 2x sided tape exacto and here ya go. Total cost about 10.00.
136780


136781
 

·
Registered
EF9 DC2
Joined
·
176 Posts
Discussion Starter #2

·
Registered
93 Civic HB SI
Joined
·
847 Posts
Gregparts FTW haha.

Printed the HVAC/gauge blanks for my dash. I've only got 2 stickers on the car:

20200718_124712.jpg

20190728_194829.jpg


He is a small outfit, but makes some badass 3D printed parts for old hondas, even OE replacement stuff.

He even 3D prints an entire replacement center console/arm rest for the 88-91 civics!
 
1 - 6 of 6 Posts
Top