Honda D Series Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
So a couple months ago I bought an EK hatch which I DD'ed until a rod flew through block one day (rod seized).
So since then I bought a block off a friend of mine and currently rebuilding.

Block had:
-Non-vtec P08 head
-ARP Studs
-P30 Rods
-Block Guard
-P2E Pistons

By the end of it, I wanna see how far I can go on a t3/t04e setup.

(Will post pics when I can actually link them):TU:
 

·
Asshole
Joined
·
4,112 Posts
P08 head is indeed vtec and p30 rods likely don't fit the p2j crank but post some pictures and ship me some jdm parts brotha. I was lucky to visit Ocho Rios and spotted this clean hatch, maybe you know it.

 

·
Registered
Joined
·
1 Posts
Discussion Starter #3
P08 head is indeed vtec and p30 rods likely don't fit the p2j crank but post some pictures and ship me some jdm parts brotha. I was lucky to visit Ocho Rios and spotted this clean hatch, maybe you know it.
I think Ive seen it before, its super clean.

the non-vtec p08 D15B came a few jdm cars from 96-00, and I'll be using that block with the 3-Stage P2J head.

I'll post pics when I'm allowed to
 
1 - 3 of 3 Posts
Top