Honda D Series Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
4,491 Posts
Discussion Starter · #1 ·
my cousin hooked me up with a y7 engine. i didnt know what the damage was but it has 3 bent rods lol. is the whole thing junk like the crank( it looks good though), block? what about the head it looks fine. in fact the head looks really good.
 

·
Banned
Joined
·
3,566 Posts
I would just take it all apart and check. Block might need to be bored or sleeved. Head may need new valves. But other than that keep the block.
 

·
Registered
Joined
·
4,491 Posts
Discussion Starter · #3 ·
I would just take it all apart and check. Block might need to be bored or sleeved. Head may need new valves. But other than that keep the block.
i did take it apart. thats how i found the 3 bent rods. now for the block it looks like it got hit by the rods. its right in the place where you "notch" it for forged ones.
 

·
Banned
Joined
·
3,566 Posts
Take it to a machine shop and see if they can bore it out safely. If so , then just get oversized slugs for it and call it a day. You are already ahead cause you didnt pay for it.
Don
 

·
The Master Fabricator
Joined
·
2,038 Posts
Sounds like it hydrolocked...
A sohc block is less than $100, time to get another...
 
1 - 5 of 5 Posts
Top