Honda D Series Forum banner

main cap

  1. over-sized main bearings

    Engine Building
    Ok everyone i will get straight to it. I had my crank reground and polished and things are not adding up. I have a set that are .010 or .25mm mocked up in the engine and plasti gauged. When I checked it with the chart the plastigauge matched up with the .003 mark. from what I've read I want...
  2. Replace main bearings cap bolts?

    Forced Induction
    Hi I am rebuilding my engine for 300-400whp. I have read a lot of building threads but never seen anyone replace the main bearings bolts, I have torqued them about 4 times because checking the clearance to 52 Nm. The Honda workshop manual does not say that you need replace them. If i should...
Top