Honda D Series Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. General Tech
    So I recently bought a 1992 eg hatch si that has a d16z6 that was bored .50mm over, CP pistons, eagle rods, BC springs and retainers, edelbrock x intake, skunk 2 70mm throttle body and garret .57 trim turbo. As for fuel and electronics it has a hondata s300, fic 1000cc injectors in a aem fuel...
  2. General Tech
    Just did my oil today and checked my plugs, no oil fouling them, and started the car up, put my thumb on each spark plug wire cap, wires 1,3,4 are feeling stable, yet when I put my thumb on plug wire 2, I feel a steady thump, or knock, no audible sound in engine, or during startup, reving up...
  3. Engine Management
    A little background about my car. I have a 2000 ek sedan with a stock D16Y8. The motor was rebuilt with new bearings, rings and gaskets. im planning on going turbo but i cant figure this knock out. It doesnt knock at idle and when you rev it up there is a sweet spot id say like 3-5k rpm it...
  4. Engine Management
    I am tuning my civic (turbo y8 ) with the AEM EMS Series 2. The problem I am having is that the vtec solenoid seems to be cutting out randomly during the driving process. The oil is topped off and my oil pressure gauge running off the 'sandwich plate' has not given me any issues yet. I...
  5. Suspension Corner
    First a description of my setup: 95cx hatchback chassis Ground Control sleeves w/Eibach springs (340 front/250 rear) and Koni Sport Yellow shocks Team Dynamics 15 x 6.5 rims [offset 38] wrapped in Yokohama 205/50 S. Drive tires 94-01 Integra front/rear lower control arms 94-01 Integra GSR...
1-5 of 5 Results
Top