Honda D Series Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 18 Results
  1. Engine Building
    Hey how’s it going everyone!? So I picked up a 1999 civic CX as a little winter project to build on the channel and I am relatively new to Honda all my other cars are American V8 so I have been searching the forums and google non stop for the last 2 weeks! the guy that had the car before me...
  2. New Member Introductions
    Hey how’s it going everyone! New to the forum I just picked up a little 1999 civic CX to build on my channel BOUGHT2BUILD someone put a D15B non vtec in it 🤦🏻‍♂️ but I have already collected the parts for the manual swap and most the turbo parts are starting to roll in so stay tuned! I will...
  3. General Tech
    Bought a non running del sol 3 weeks ago. I got it started finally to find out that I might have a head gasket leak. Well today got the head off and sure enough the gasket was bad. Do I need to bore out the cylinders? D16Z6
  4. General Tech
    So we know moates stopped production of the ostrich 2.0, what is the next thing how do i tune my car with crome? I’ve been doing some research and I’ve had no luck. Any help is appreciated cause I wanna tune the car!🤣
  5. Engine Management
    i haven’t been able to find a clear answer or recommendation for a aftermarket fuel pump replacement on a bone stock d16y7 set up. is a walbro 190 a good idea, or should i got with the DW 165 lph
  6. Transmission alley
    I have had no finds looking for this question, I need a new transmission and I found one but it’s out of a D17A1 so it’s a 1.7 transmission. Will that trans bolt onto my D16?
  7. Naturally Aspirated
    Hi, I’ve been searching a bunch of forums and have not found any answers that solve my problems. So the motor is a D16Y8 with a P72 ecu. I don’t have a CEL as the motor is in a classic mini. I have hooked up a light to pin 13 on plug A to ecu (Malfunction Indicator Light) according to things...
  8. General Tech
    Hi all, I've been trying to exorcise the demons out of a 92 Civic hatch with a D16Z6 5 speed swapped into it. I've been lurking the forums for years, but I'm running out of ideas and things to test. Apologies in advance for the long post, it's been a long, long running problem The main issue...
  9. Engine Building
    Hey so I just got this d16z6 back up and running, and upgraded my head to Brian Crower 1070 springs for the cam I’m planning on getting, I’m running stock cam right now. Since then I have had a rough time getting it on time. I have not clue why? It seems like it skips 3 teeth back. How do I fix...
  10. Engine Building
    I have 2 D15B2's one in a CRX and another in an EF hatch. Can anyone list what i need for the mpfi swap? As much info as possible including part numbers would be appreciated. Looking to upgrade and have heard this is about the best thing for a d-series. If there is a head swap i could do to get...
  11. General Tech
    Swapped out my d16 for a new one and won’t start , the problem before was the crank, and I used the old head checked to make sure it has spark and gas (it does) about to check to see if it had compression other than that the ecu and the starter were fine before the swap please help it has a slow...
  12. Transmission alley
    I was wondering if I could take a fwd tranny from a 88 civic wagon and put it in a 88 civic hatchback
  13. General Tech
    This is my first civic, and only my second vehicle ever, so I have very little knowledge or experience 🤣 I've been told the d16y8 head is really restrictive and that's why they apparently don't respond as well to all the bolt on upgrades as others. I've found a lot of seemingly contradictory...
  14. General Tech
    In need of a honda guru !! 91 civic was dpfi now mpfi with a obd0- obd1 jumper harness and dizzy jumpers Has a d15b8 running po5 ecu My fuel pump will no longer prime just stoped priming drove the car 2 twice I have 2 ecu's now same problem If I put the stock pr4 it will prime no problem I have...
  15. General Tech
    Hello everyone! I am currently finishing up a simple y8 setup for my 99 EX coupe. SpeedFactory no-notch rods, 75mm Vitaras, King bearings, ARP head studs, and BC valve springs/retainers. Everything is together, but as I was putting the valve cover on I noticed there was an empty threaded hole...
  16. General Tech
    I have 2005 Honda Civic SI with 145k on the engine, Manual I want to put a turbo on it, I drive ALOT and I want somthing more fun to drive, ya I could get a new car but I like my older civics because I can actually fix them lol I have been trying to find a clear answer to my questions but I'm...
  17. New Member Introductions
    Hi guys, I am thinking of buying an automatic (CVT) Honda Logo as a daily. I would like to know some info on them, like reliability and MPG, and how to tell if it is the Sport (TS) model...
  18. Wheels and Tire zone
    I'm looking for just one of these rims. I've been looking for weeks. Posted other places and keep coming up empty. The closest I've come was on a site that had some that looked exactly the same with 15 spokes but they only made them in 17 or 18" I need a 15" 4x100. If anyone can help I would...
1-18 of 18 Results
Top