Honda D Series Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

41-60 of 61 Results
  1. Transmission alley
    Hello all, and thanks. Last weekend I did a auto to manual swap on my 99 civic ex. The tranny was from a 98 civic ex. Anyways, everything works fine, however for about the first 10 mins, the car idles from 1500-2000 up and down every few seconds or so. I plan on doing this for the fix: Any tips?
  2. Engine Management
    Hey guys. While driving home today my car started to sputter so I pulled over and then it died. When I went to start it again I could hear something in the ECU kicking on a relay really fast. After I got her towed home and started looking at her in more detail (no fuses blown, ECU PCB in good...
  3. Engine Management
    i have a p28 currently in my ecu and my brother has the identical car that he bought with a p28 ecu that has been chipped/hacked open. His ecu has higher rev limiting and basically no need for the second oxygen sensor. some people say i couldn't be done but his was bought that way. My question...
  4. Engine Management
    Hey, I'm new so this is probably a stupid question; but I need to know. I just bought a 97 EX, which I'm assuming is a Vtech D16Y8, and I'm not sure but I think I need to chip, tune, or replace the ECU. The car has 4in dual exhaust, with h-pipe of course, short ram intake, Konigs, few suspension...
  5. DOHC ZC
    so i was at the local scrap yard when i saw a rusted out ef. so i pop the hood and what do i find a JDM DOHC ZC. i ask the guy how much he wants he says $400 i offer he 300 and he says yes. so now i bring the car home and have the engine pulled ot put in my 89awd wagon. the ecu that came with...
  6. Engine Management
    I have a p28 ECU. I was wondering if it would have any advantages if hooked up to a NON-mini Me set-up(non z6 head). I have the a z6 head, just wondering if I can just plug this thing in and start using it before swapping the head. I do have the odb1 wiring, so I know it will plug in...I just...
  7. For Sale
    ................
  8. Engine Management
    im pretty new to this ecu tuning stuff so bare with me. i have a '99 civic ex with a D16Y8, stickshift. it has CAI, Header, and Exhaust. i have a P06 converted into a P28. i have made this tune but im not sure if it will damage my engine in anyway. i need you tuners advise on my tune. i have a...
  9. Engine Building
    I've been saving up for a while, and doing a bit of research on what I should do. First, specifics: I have a d15B8 with a little over 200k sitting in my 95 hatch, and a D16Y7 block in the shack with roughly 60k. In the beginning I got boost happy and bought a turbo rebuild kit for the D16Y7...
  10. General Tech
    ok guys so i have a jdm d15b and i recently bought the P08 ecu and before i changed it i had the P28, now i did have the cel on before i changed it but it was a code 6 (ect sensor) but i changed the sensor and the computer at the same time so when i turned the car on the light was gone.... that...
  11. Engine Management
    i have a 92 honda civic with a jdm d15b running on a P08, the code it gave me was dash dash dot, can someone tell me what the codes means?? thank you for your time
  12. Engine Management
    Hey guys aight so I have a jdm d15b running on a p08 so my cel is on and I did the old paper clip method and it gave me a code six. So with that said I did some research and I believe is the ect... Ok with that said I changed the ect and the light is still on with same code then I changed my cts...
  13. For Sale
    I've got eight ECU's here that have been chipped and socketed and are ready to be tuned. All ECU's come socketed and include a reflashable chip and a datalogging connector installed for use with a Moates.net HULOG/Extreme HULOG They come with standard basemaps or I can provide custom basemaps...
  14. Engine Management
    Its posible Wideband to Narrowband (1-wire OBD0)? with AEM uego 0-5v?? Hello!! My ecu have O2 sensor because its catalyzed, but only one wire (i think 0-1v) I can convert 4-5 wire wideband to 1 wire narrowband signal? thanks!!
  15. New Member Introductions
    So my 96 Del Sol SI with D16Y8 engine should have the P2P ECU. Then I noticed the label and it says P28. Getting curious, I took the cover off and saw this. This looks like a P2P ECU. But then I saw the marked area and it looks like a Integra ECU. Can anybody confirm what ECU I have? Thanks
  16. DOHC ZC
    Hello!! I have catalyc dohc zc engine, with O2 sensor, but i founded and PM7 of non catalyc dohc zc, this will fit on my car and work the O2 sensor (don't break the catalyc converter)??? Thanks!!
  17. General Tech
    I need to buy an ECU for my JDM D15B Vtec. P08 seems like non-existent anymore. So is the P08 same as P28? Are there are any differences with these two units? Is there a difference with wiring? Or if I buy a P28, would I have to remap it to be a P08 or something? Am already having troubles with...
  18. DOHC ZC
    i have a 92 civic and i am swapping to a dohc zc of course the 4th gen engine but i was going to keep my car automatic. well i have researched on this but didnt find much, so my question is will a acura b18b auto ecu run my zc without causing a rich condition, if not the what ecu do you...
  19. Engine Management
    I have a very crusty 95 dx 4 door with a jdm d15b swapped in, manual trans lsd (at least I think it is, chirps either tire). The ecu that was sent with the drivetrain is a p91. Even though they kept assuring me that it is compatible with a p08 , and or was chipped with a p08 chip, blah blah...
41-60 of 61 Results
Top