Honda D Series Forum banner

crx

  1. Climate Control Help

    Audio/Electronics
    Hey guys im fairly new to this forum so sorry if in wrong area. I have recently read about putting an EG civic climate control into a CRX. I have since done the conversion and am yet to mount it. But i have been having trouble with the actual cables, Im not sure how to mount the cables as both...
  2. Civic SI D16a9 Oil Pressure

    DOHC ZC
    Hello Everyone. I´m Axel From Argentina.. I have an Honda Civic SI 1993 with D16A9 ( japaniece version ) Please, can anyone tell me the values to check the oil pressure??. the car runs perfect but I will make all services with original parts including water pump. I afraid to replace the...
  3. NO Spark Dohc ZC

    General Tech
    :ninja:3rd gen Dohc ZC. Obd1 with Chipped p28 ecu with respective basemap. I already checked for signal at the ecu. I've used an ohm meter and test light on power source to dizzy. Changed cap and rotor. While it was off, I checked for power at the shaft, and nothing. I took ohm tester to every...
  4. 91 CRX Si D16A6 rebuild question

    DIY Forum
    Okay so I rebuilt this engine with the mechanic I used to work with(35+ years experience). He had me questioning a lot of what he said because of certain circumstances. My question is after I got the rods and pistons in I had trouble turning the crank. We switched out pistons 1 and 3 which...
  5. The story of The Devil CRX (Build Thread)

    Showcase
    I’ve had my car for 12 years and I’ve never made a build thread before on my car. I don’t have every step of the build and can’t remember all the details of everything so I’m just going to share my build via a story/history of the car. I have taken pictures here and there during this time so I...
  6. JRSC D16Z6 in CRX

    Forced Induction
    Hey guys, I'm finally planning to do the JRSC swap into my CRX mid-September, more than a year after starting down this road. An unheated garage in Minnesota and recent move out of state put me behind, but I'm ready to go now. I have a D16Z6 with JRSC that I want to put in the CRX. Does...
  7. Rebuilt tranny, stuff loose inside?

    Transmission alley
    Hey guys. Just got done rebuilding the tranny for my 87 CRX Si (GW2 trans) and put the thing together. In the process of moving it off the bench I noticed that there's a little noise coming from inside, kinda like some shaft is loose and slopping back and forth just a tiny bit. I don't know if...
  8. D16A6 Block - mix n match pistons?

    Engine Building
    Hey guys, maybe I missed somethin but I just noticed this a6 block I picked up has two different sets of pistons. I'll have to get hone and check the stamps, but 1&4 are one type, and 2&3 are another. This isn't stock, right? And what can I expect when I put this thing together in terms of...
  9. d15z1 HELP!

    General Tech
    hello guy. im new to this community so please bare with me. I have a crx that I bought and from what the previous owner told me it came with: d15z1 block y8 vtec head y8 intake manifold with a gsr throttle body and a p07 ecu so heres my problem. my rex shuts off at a stop or when in neutral...
  10. D15B1 Z6 mini-me swap

    Engine Building
    I have a 89 CRX that I am swapping. everything is bolted up right. I kept the old intake manifold so that I didn't have to convert it over to MPFI. I had to do some wiring to get the z6 dizzy to connect. But it still wont start, is there a way to get the old dizzy to bolt on? PLEASE HELP!
  11. Can't find diagram of whole crx suspension system ?

    General Tech
    after searching all over, i can't find a picture of a diagram of the whole crx suspension system, all attached together, showing the subframes and front crossmember along with the front and rear suspension parts attached to them ? showing it how its all attached together on the car, but...
  12. need help on buying correct stereo wiring harness for crx?

    Audio/Electronics
    when theives stole my head unit, they cut the wire harness plug off, so its just a wire loom with all the multi-colored wires in it, all cut at the end, with no plug at the end of it, i read that i need to buy a "reverse wiring harness adapter" ?, that you attach to the cut harness...
  13. WTB Speedometer cable for manual transmission: 1988-1991 Civic / CRX

    Want to Buy
    PM me your price shipped. I already have two outer cable casings, so if you have only the inner cable that would be great too. Otherwise, I will take what you have as long as the price is right and that darn thing works. Thanks Speedometer cable for manual transmission: 1988-1991 Civic / CRX...
  14. Smallest Honda Driver? 2Ft 9inches :)!Help!

    New Member Introductions
    Hello everyone my names Joseph I'm from FL I am 28 years old. Diagnosed with Brittle bones disease I moved here to FL about a little over a year and a half and bought myself a 1991 Honda CRX as a project car. Modding the stuff broken and old stuff as I rip it out. Looking to stick with the D15B2...
  15. WTB: 88-91 manual steering rack!

    Want to Buy
    I'm looking for an 88-91 Civic/CRX manual steering rack. DX/STD/SI prefered (No HF please) Hatchback or CRX should work not sure if the sedan or wagon are the same. (Needs to fit my 89 hatch) I have cash or pay-pal "Gift" for anyone that comes through. I'd prefer to find one somewhat local to...
  16. stiffer springs for a stock height crx?

    Suspension Corner
    Ok, I've been having issues with the stock springs being a bit too squishy with a second person in the car. I could care less if it rides like a go cart as long as I'm not scraping my header against the ground every time I hit a little bump with a passenger. Any recommendations for a stock...
  17. Mini-me swap.. confused.

    New Member Introductions
    I know there are numerous posts/guides/info and what not on this subject, but I haven't found any simple solid instruction that is specific to my situation.. or maybe i have and just can't wrap my mind around it so here it goes... I have an unmolested 89 crx si, did a compression test, and...
  18. A CRX love story.

    Engine Building
    Hi there, I am very new here, my name is Cory. So here goes. My first vehicle was a 1986 HF Honda CRX. I loved it to death until I let my friend get in the driver seat. He blew the engine to pieces doing a burnout I told him not to do. What a great friend. The car however is still great for...
  19. D15z1 swap into a 89 crx si

    DIY Forum
    What's up everyone I'm new to this Honda tech stuff I have little background in mechanics but I need help ASAP I am trying to drop an obd1 engine into a 89 crx si that has obd0 harness I have the harness and computer from the 93 civic DX that the obd1 harnes is in and ecu can I just swap the...
  20. thoughts on tokico illuminas?

    Suspension Corner
    Hey guys, just wondered if anyone else runs tokico illuminas and what you think about them? Doing a drag build on my car but also drive it to shows. Have progress springs on now as well.
Top