|01-15-2006, 07:41 PM||#1 (permalink)|
Join Date: Feb 2005
Location: upstate NY
Rep Power: 15
iTrader Score: 20 reviews
Today I swaped a 95' D16A6 motor into my 90' si. The clutch on the motor is the same one from the 95' witch was had the hydro S20 trans, I am still using my cable Si tranny with the same throwout bearing in the car though.
My problem is, I bolted the engine up in the car, hooked up the clutch cable. But with the cable adjuster all the way out. The clutch pedal still goes to the floor about 3/4 before pushing the clutch in. There is a lot of play in the arm on the trans.
Do I have to use the 95' throwout bearing with that clutch, if it even works in my cable trans?
Or do I have to use a 90' clutch on the motor instead? The clutch on there is a brand new 6 puck, so I would rather keep it on there if I can.
91' CRX SiR EF8
92' Civic, ek frontend B16
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|