Leak between block and manual trans - D-series.org

Go Back   D-series.org D-series Knowledge Factory General Tech

D-Series.org is the premier Honda All Forum on the internet. Registered Users do not see the above ads.
Reply
 
LinkBack Thread Tools Display Modes
Old 03-30-2018, 04:39 PM   #1 (permalink)
n00b
 
iTrader: (0)
Join Date: Jul 2016
Posts: 3
Rep Power: 0 everesev is nobody
iTrader Score: 0 reviews
Default Leak between block and manual trans

I just did a complete rebuild on d15b1. Even rebuilt the 4 speed trans. The problem is that's it leaks out the weep hole between block and trans. I pulled the oil pan and resealed it. Still leaked. Pulled trans again, new rear main seal,...still leaks. It leaks about a few tablespoons when i park the car. If I start the car and let it idle it doesn't leak. Only after a drive around the block it will leak then stop. Sort of like the oil drains to the pan and then it stop. I cannot believe the crank needs to be sleeved or was in poor condition so sealing is bad., Upon inspection the crank surface looked fine. Pilling the trans again would suck as I want sell the car (90 civic wagon base model). Any thoughts out there?
everesev is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old 04-02-2018, 07:42 AM   #2 (permalink)
\/Your Mom Was Here\/
 
BeerDrinkin's Avatar
 
iTrader: (11)
Join Date: Feb 2010
Location: South of Nashville
Posts: 4,825
Rep Power: 54 BeerDrinkin is on a level you can only DREAM about! ! !BeerDrinkin is on a level you can only DREAM about! ! !BeerDrinkin is on a level you can only DREAM about! ! !BeerDrinkin is on a level you can only DREAM about! ! !BeerDrinkin is on a level you can only DREAM about! ! !BeerDrinkin is on a level you can only DREAM about! ! !
BeerDrinkin is on a level you can only DREAM about! ! !BeerDrinkin is on a level you can only DREAM about! ! !BeerDrinkin is on a level you can only DREAM about! ! !BeerDrinkin is on a level you can only DREAM about! ! !
iTrader Score: 11 reviews
Default

Input shaft seal on the trans could be leaking

Distributor O-ring or valve cover gasket could leak from the top and drip all the way down to that area
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

2005 Civic EX Sedan (ES2)



To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

You will be missed but not forgotten.

Quote:
I actually jerk off to my rep points, neg rep makes me thumb my bung, what now brown cow? I finished twice.
BeerDrinkin is offline   Reply With Quote Quick reply to this message
Old 04-02-2018, 02:39 PM   #3 (permalink)
D-series G0D
 
mattliston's Avatar
 
iTrader: (10)
Join Date: Apr 2009
Location: La Crosse,WI
Posts: 5,771
Rep Power: 32 mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !
mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !mattliston is on a level you can only DREAM about! ! !
iTrader Score: 10 reviews
Default

Did you look at the input shaft seal when you removed the transmission the second time?

What color is the fluid?

not leaking parked, but leaking after driving kinda points finger at tranny fluid
__________________

2003 Hyundai Sonata GLS 2.7 Delta 197k
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

1998 Cadillac Seville SLS just broke 100k
2001 civic LX coupe MTX 199k
Sometimes, the difficult path is the easiest path
D/B/F/H/K compression questions?

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.



To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Build what you have!
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

mattliston is offline   Reply With Quote Quick reply to this message
Old 04-02-2018, 07:14 PM   #4 (permalink)
Meat Popsicle
 
Paterico's Avatar
 
iTrader: (14)
Join Date: Jan 2009
Location: San Antonio, TX
Posts: 2,887
Rep Power: 28 Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !
Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !Paterico is on a level you can only DREAM about! ! !
iTrader Score: 14 reviews
Default

You said you rebuilt the transmission. Did you replace the input shaft seal?
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


R.I.P. Pat Primmer
Paterico is online now   Reply With Quote Quick reply to this message
Old 04-11-2018, 04:38 PM   #5 (permalink)
n00b
 
iTrader: (0)
Join Date: Jul 2016
Posts: 3
Rep Power: 0 everesev is nobody
iTrader Score: 0 reviews
Default

Long story short, I replaced POV thinking about too much pressure in block. Still leaks as before. I guess the Tranny must come back out. I did a complete rebuild of 4 speed manual. New synchros, bearings, seals....etc. I meant PCV valve. I cannot express 4 letter words here, but you all know where I am coming from.
everesev is offline   Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the D-series.org forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


iconAll times are GMT -8. The time now is 12:51 PM. | Welcome to Forum, please register to access all of our features.