coolant lines for intake and tb

[sandypro]

97 dx with z6 intake got all the vacuum lines hooked up but confused on coolant lines. using the y7 tb so there is the coolant taps on the bottom of the tb i know one is coolant in and one is the coolant out but what is the routing prior to and after this ( coolant comes from block where, goes to tb and goes back to the engine how?) i just need the route and i can figure it out please help:(

[crazi-85crx]

Lines run from the thermostat housing (on the block) into the iacv (on back of intake) then out of the iacv and into the throttle body then out of the throttle body and into the intake manifold (near the heater hose).

[slebidia]

I bypass the IACV and throttle body coolant lines on all of my cars.

[dkid15]

i will be doing this soon on a 96 dx but itll be a little easier im just converting to obd1 and using a 2 wire iacv and z6 tb.

[sandypro]

i got that setup to but im also confused on that if i have the conversan harness and ecu you just have to cut the wire for the iacv and plug it all in and you good. if thats the case ill just do that to. good lookin on the coolant lines too :)

[dkid15]

so let me get this right your running an obd1 ecu with a three wire iacv, thats a no no.

[sandypro]

no im getting ready to finish the mani swap i have both tb and both ecus i was unshure about the obd 1 wswap so i was gonna use the y7 tb and stay obd1 but you say its eaiser to just swap to obd2 im confused on the wire cutting part

[sandypro]

i ment stay obd2 and cange to one whats the full process