a6 cam question

[excrx]

I am looking to upgrade my cam soon,and run a 55 or 75 wet shot of nitrous.I was wondering dose anyone make a d16a6 cam thats not a regrind,and that is a good match for nitrous?I dont mind buying new springs and retainers. I have searched and searched but I can not find an answer.

[s_18]

Bisimotos cams are top notch, regrind or not.

[88cr-rex]

what is wrong with the stock cam?

[89civicracer]

I have a JG301X cam, valve springs and titanium retainers for sale shortly. (all items are from JG Engine Dynamics) I am getting it out of my car right now cause i am swapping to a Z6 head. IF you are interested, PM me. I was eventually going to run nitrous on it. . but i wanted to build the A6 up before hand. I decided to go a different route. . .Now i will be vtec possibly with nitrous. .

[S2R Honda]

Bisimoto=Web Camshafts. They have a re-grind that works well with nitrous. I you really want a non re-grind you can try to find a Crane Cam. the d16a6 cams were discontinued about a year ago, but maybe you can find one.

[SOHCinWA]

Bisi can grind you a cam for your exact setup. A hard welded cam will not be too cheap . But IMO getting a camshaft that really fits yous own setup is totally worth the money than an "off the shelf" cam.
Don

[bgladfelter]

Colder plugs, retard timing :)

hehe. Exospeed cam and ISKY titanium valve springs new in box for sale.

Most a6's are regrinds and rock well though.

[ibcnya]

Are these cams marked in any way to tell the differences?? I got me a cam from a A6 engine with a pm3-3 Head on it. I know I need a Y8 cam gear to use this cam in my d15. What kind of gains can I expect from this cam swap??

[88cr-rex]

I will have to check to see if my a6 cam has anything on it.

The difference is noticable however, it felt much smoother above 3000. I think the b2 cam ran out of steam at about 5500 whereas the a6 pulls to 6200.

I did not dyno test it, but I did install the a6 before I converted to MPFI.