Blox IM ?

[T-MacK]

:TU: Hey whats up. Just ordered a Blox IM from pro street. Question to anyone who all ready has one, did it come with IM gasket or should I go ahead and just grab a new one. Thank's.

[Green 91]

i belive ryan89crx has one.
just get a hondata style one

[T-MacK]

Yeah that was my initial plan. Thank's I'll just go ahead and grab one.

[ryan89crx]

it doesnt come with any gaskets. you need a new IM - block gasket, and the IM - TB gasket

[replica]

Wish more people would comment if it clears the firewall in crx's...

[ryan89crx]

Wish more people would comment if it clears the firewall in crx's...it clears just fine with the help of a BFH

the only thing that comes close to hitting is the IACV. so measure where that is going to end up on the firewall and bash it in with a hammer. thats all i did and it works just fine. i would recommend motor mount inserts though so that the motor doesnt rock back far enough to make contact

[T-MacK]

^^ Thank's Ryan. I will be ordering both parts tomorow.

[AMkrew_1]

Ryan's dead-nuts-on, as usual.

I have an original skunk2 manifold in my crx, and the BFH was used for the IACV, and behind the tps. Also, I remember reading on here somewhere, that someone ground down the ends of the IACV bolts to get a bit more room, which I did as well. It's really an easy swap. Make sure you've got some vacuum caps laying around, though. I didn't use all the vac ports until I boosted it. 2 extra in fact, on the oiginal skunk2 z6 mani and obd-1 throttlebody(throttle-mounted map setup).

-josh-

[replica]

it clears just fine with the help of a BFH

the only thing that comes close to hitting is the IACV. so measure where that is going to end up on the firewall and bash it in with a hammer. thats all i did and it works just fine. i would recommend motor mount inserts though so that the motor doesnt rock back far enough to make contact
I assume BFH is big fucking hammer? Hmm, is there a way i can get it to clear without damaging my car? I have ESMM's on order...is it really worth denting the firewall for the manifold? I've got a SOHC ZC...88-91

[ryan89crx]

I assume BFH is big fucking hammer? Hmm, is there a way i can get it to clear without damaging my car?its not damage, its "modifications" lol

once the mani is installed, you cant even see where you dented the firewall

[remoer]

hey if you have a set of calipers can you measure the tb portside to know what size it is on the blox im. this would begood info to know or at lease for me to know.

[T-MacK]

[QUOTE=ryan89crx;877798]its not damage, its "modifications"

Hell yeah, I personally know all about these types of "modifications"