d16a6 build

[allmotorsingle]

i started my d16a6 build... just got the bottom end assembled doin the top tommorrow...

[ef9turbo]

nice... keep up the good N/A work!

[greasemonky50]

cool keep us posted

[allmotorsingle]

here goes some more pics.....

[allmotorsingle]

the head is a stock y8 soon to be built to but i need the car to be done to get to work=( to get the money...so htat has to wait...ill have more pics tommrow cause im droopin it in.......

[mamasboy]

whats it being installed in,and what have you done to the motor??thinking of rebuilding a d16a6,wanting to know my options

[Talha]

which pistons are u using???

[Talha]

can any one get me used pm7 or new pm7 pistons ???damn they r not available in pakistan...these will be going in my d16z6 block

[allmotorsingle]

im usein pm7 piston for the high comp with the y8 head..... i drooped it in today into my 95 coupe dx ......now i gotta brand new 6 puck clutch and when i put it in gear its like the pressure plate is not engaging...i blead it about 5 times and still nothing....and the idle is going up and down from 1000-1500 rpm...anybody now the problem answer me asap.......but she starts rite up wit no problem sounds good fluids are good temp is good but the clutch is waked............helpppppp thank you

[allmotorsingle]

here go some more pics.....

[Mixelplix]

Loopy idle is a vac leak, or a dirty IACV. There's a DIY for it here somewhere in the DIY section.

-Des!

[mamasboy]

any idea what kind of hp you'll get outta this setup?picked up an engine for 40 bucks(d16a6) and want to replace my burning d15b7,,any problems with the swap?thx sc

[remoer]

well i'm doin the same kind-a-build up, in sense w/a full race head w/an aggressive pnp, stage 3 cam and all the icing. a basic build like w/a better cam can yeild 145-170 hp/whp. i can't remember which one. i was told with how aggressive i'm going w/itbs i should see around 200whp allmotor, give or take several whp ponies.

[allmotorsingle]

i have like no trottle respose at all...when i give it gas its really lazy like i put it to the floor and it goes no where......wut is the problem now

[NEP-tuningalltheway]

did you break it in check the timing any codes

[allmotorsingle]

not i just started it up.. but i should still have some type of response...the timing is dead on....could my p28 be bad

[NEP-tuningalltheway]

do you mean its not reving when you push the throttle?

[allmotorsingle]

not it revs it just takes to long...like it has no power......

[NEP-tuningalltheway]

not it revs it just takes to long...like it has no power......

why dont you go drive the car?

take it around the block dont mash on it yet your rings are not seated yet. is the car smoking

[allmotorsingle]

no smoke at all.....could it be a wiring problem?......

[NEP-tuningalltheway]

Go Drive It

[allmotorsingle]

well i went and drove it got 66 miles on it so far..... but its still not rite it will not run wit my p28 i had to use my boys gsr ecu... and then it was fine..i just gotta get my bugs fixed its always somethin.......