Cam gear / sprocket

[cation]

I've got a quick question. I recently replaced the head on my d15b2 with one off of a d16z6. Everything is back together but I think I may have a slight problem....My cam gear looks as if it is at an angle relative to my water pump and crank pully sprockets. I've turned the engine over several times to check and see if the belt will slip off but I can't get it to. Also does anyone know where I can get the dowel pins that go in the block for the head to line up too. I think that may be my problem but I'm not positive. Any help would be cool. Peace out honda freaks.

[-TJ]

You didn't use the dowel pins to align the head to the block? Hell yes that's going to be a problem.
Buy the dowels at Honda, or go to the junkyard and try to scavenge some. They are the same as the ones pinning the tranny to the block, but don't just rob those, you need them as well!!

[DOG]

Get the dowel pins and start over. Remember the tqing sequence too. Use the z6 specs. Also check your head bolts and make sure your using the right ones.