FMYStreetRacer
04-14-2004, 08:08 PM
i got my new motor the other day and the only real things that i need to get the motor intot he car is a head gasket and a clutch. i wasn't planning on buying anything else for it but i bought a turbo kit that i found a good deal on and now i have no money to buy a clutch. i did buy a used y8 block a while back that has a C.M. 8lb. flywheel on it and it has a act clutch that was grabbing good when i last rode with the guy, he took the motor out 3 days later. i looked at the cluitch when i got the block and the clutch looks pretty worn and the flywheel has some bad looking heat spots. i was planning on buying a 4-6 puck sprung clutch. my question is this, do i need to buy the new insert for the flywheel even though i am going to be useing a puck clutch? i know that the puck disk will put some heat spots on it alone and will cause some chatter. or should i just put the motor and trans in with the old light flywheel and act clutch and then buy new shit and swap it out later? i can't go much longer with this b2 motor, it's just too slow.