obd2 to obd1 question

[HONDA300]

i just bought a skunk2 p28 and a conversion harness for my 96 ex3 and was wandering if other than pluging this in, is there any thing else that will have to done to make it work?

[civic97]

everything should work what map is on the ecu?

[ILikeShinyThings]

You should get a Y8 map put on the ECU.

www.moates.net
www.xenocron.com
www.cjperformance.com

[HONDA300]

i'm not sure what the base map is, i'm guessing z6 but it has a moded skunk2 chip.

[Sohc Wrath]

i'm not sure what the base map is, i'm guessing z6 but it has a moded skunk2 chip.

It would be the z6, all of those chips are the same. They put out a lot of timing and to much fuel, if it was crome or uber then you could put your own basemaps on it and get it running the way you want...

[NEP-tuningalltheway]

is it real skunk2 or ebay chip with a skunk2 sticker that just dumps fuel and lets you rev the shit out ofit?

[HONDA300]

its a real skunk2, i got used off my friend who bought it from skunk, but would it be a good idea to up a vafc on top of it to fine tune the fuel flow

[lsturbohatch10]

no Vafc if you already have a chipped ecu get crome and a burner from moates and burn your own chip. then you can have launch control and all the other goodies. hell thats the only reason i would convert to obd-1 anyways