PDA

View Full Version : dizzy leakin


monkeyin
12-18-2006, 10:04 PM
my 92 civic hatch's distributor is leakin and i just change the o ring on that thing and still leaking a little bit and the oil light is on!!:cussing: Please help me

dustin_crxsi
12-18-2006, 10:07 PM
....yea that isnt too healthy. Is it comming from around the cap, or from under/around it?

monkeyin
12-18-2006, 10:14 PM
its coming out from under but nowhere near the cap the dizzy still works fine but its comin out where the distributor connects to the engine and cams. it looks like i didn't bolt it in enough or something but i know i did but yea the engine light is on too!!

dustin_crxsi
12-18-2006, 10:17 PM
ok, there is your problem, were you messing around with it? take your dizzy out, and check for the rubber ring around the extension, that goes into the head. If that isnt there, thats the reason. and If that is the case, did a bolt come undone? there should be 3 bolts for the dizzy.

Levi
12-18-2006, 10:18 PM
sounds like the shaft is bent on the distributer. I had that happen at one point. Replaced 2 o rings until I swapped out the distributer. I think your engine light might be on for a seperate reason, go pull the code.

dustin_crxsi
12-18-2006, 10:19 PM
he could have also messed up some sensors in the dizzy. It may be the crank angle sensor.

what code is it throwing?

monkeyin
12-18-2006, 10:25 PM
my bad not the engine light but the oil light my bad.

dustin_crxsi
12-18-2006, 10:26 PM
CHECK YOUR OIL DIP STICK!!! If its really low, you better hope you didnt mess anything up

did the car start running hot?

monkeyin
12-18-2006, 10:36 PM
ok, there is your problem, were you messing around with it? take your dizzy out, and check for the rubber ring around the extension, that goes into the head. If that isnt there, thats the reason. and If that is the case, did a bolt come undone? there should be 3 bolts for the dizzy.

ok like i checked it and there is one ruber o ring on the extension the goes connects to the cam. i just got that rubber on ring at the dealership too but is there suppose to be two rubber ring. also i could you tell if the extension rod on the dizzy is bent.

dustin_crxsi
12-18-2006, 10:38 PM
spin it, see if it wobbles


do you have aim, or msn, that I can talk to you on there?

monkeyin
12-18-2006, 10:39 PM
no it has oil and everything i know that for sure but this motor is a motor i got for free to put in my shell but like the guy said it ran fine and the engine was alright it cranks and i got spark but i just got to redo the timmin it is off but i havent been able to take that stupid bolt out i twisted one of my wrench trying lol.STUPID BOLT

dustin_crxsi
12-18-2006, 10:42 PM
lol take it easy. Im sure this is your daily driver, but dont get mad lol. Take your time, If you have to get a bolt out set. I've ran a car with only 2 dizzy bolts. as for your timing, I think you can rent one from autozone


where are you located?

monkeyin
12-18-2006, 10:43 PM
u can call me man i got free minutes rite now but yeai havent used aim or msn in a long time it does move back and forth but it looks like its suppose to cus wen i spin it its ok. but u can move the very tip back and forth just a little. doesnt' seem like it is bent

monkeyin
12-18-2006, 10:44 PM
5039278639 i got free minutes nation wide so yea it u dont then it aight.

dustin_crxsi
12-18-2006, 10:44 PM
umm sure, whats your number?

monkeyin
12-18-2006, 10:57 PM
thank so much