Head Work

[fat_85_civic]

Hey

I’m about to do some head work on my D16A3 which is vary similar to the D16A1 or ZC1 and need some advice on parts to use.
MY plan is :
- Port match IM
- Polish Exhaust Port and CC
- Clean up ports a tiny bit
- 3 angle valve job
- Shaved for about 10.5-11:1 comp
- New (or stock if they can handle it) valves with a 30* back cut and undercut stems to improve flow
- New springs and retainers in necessary
- Cams

Ill be doing most of the work myself except the shaving and 3 angle valve job.

What I need to know is :
- Where can I gat valves for this engine and are they the same as any other engine?
- Where can I gat springs and retainers for this engine and are they the same as any other engine?

I have looked at crespo for the springs as they seem cheap and it is a good company but I will have to decide on my cams first.

Edit: I just got a PM from Jason@Rage and hge said the omnipower valves he is selling will fit. I would love these valves as they wil help imcrease the CR and they are cheap. Does any one have theese valve? What do you think of them?

Thanks
Luke

[champneys05]

ebay man

[crxdude]

egay ftw

[fat_85_civic]

iu meant like brands, not ebay.