camber kit problem

[lilryanadamse]

i have a camber kit on my car but there is a slight problem. it is the one that goes onto the control arm that goes into your strut tower. well, there were some spacer rings around the part that goes up into the strut tower to make it snug, but they were too big and would not fit. so now there is a little play where it goes into the strut tower becuase it is also too small without the spacer rings. what should i do. if i did not make my self clear, let me know and i will try to clarify further. it is late.

ryan

[Dweezil]

It should be a really tight fit, if you need to take some really fine sand paper and lightly sand the spacers to get them to fit tightly in place.

[lilryanadamse]

i will try that, but i think the spacers would take forever to sand down.

ryan

[modsHXcivi]

i will try that, but i think the spacers would take forever to sand down.

ryan

Use a belt sander ...

[94z6ex]

i will try that, but i think the spacers would take forever to sand down.

ryan

quit bitchin and do it.
i hope they take 9 years to sand down ;)

no but seriously, good luck....

[lilryanadamse]

belt sander. nice.

[lilryanadamse]

i slid the stock piece into the hole in the strut tower and it has some play too, so i guess it is not a big deal if it is perfectly snug. i am going to do some polly motor mount inserts because one of mine is broken and see if that fixes it.

ryan