d16y8 stock header?

[isbluesmokebad?]

I have a 2000 Canadian Si, which is basically an American EX. I recently had to buy an exhaust flex gasket, which was a pain in the ass to find. All the ones i kept getting were too small. I looked more closely and it turns out the car has a welded tubular 4-2-1 "header" instead of a cast manifold like all the other ones i've seen. Are these fairly common? Everyone i've talked to around here (California) has never seen one before. I'm 100% sure its stock. Btw, i did end up finding the right gasket eventually from honda.

[Dweezil]

Post a pic of it.

[DirtyDC4]

It came on 99-00 EX Civic's here (I believe). Yes it is factory. Yes, I've seen one. Yes, it is kinda niiiiice.

[K2e2vin]

Check out the "moosified" header. He got his from a D16Y8 off of a Acura IIRC(don't remember which model).

[Dweezil]

Acura EL, only one sold with a D motor.

[isbluesmokebad?]

It came on 99-00 EX Civic's here (I believe). Yes it is factory. Yes, I've seen one. Yes, it is kinda niiiiice.

i wonder if it's good for any extra power.

[isbluesmokebad?]

Post a pic of it.

sorry, i'd have to pull the heat sheild off to do that and i'm pretty lazy today lol

[isbluesmokebad?]

actually i found a pic online.
http://www.hadamotorsport.com/tech/review/dsemc/d16y8-00.GIF

[amej8]

Acura EL's have that header. They are pretty much a copy of Honda Civic's.

Owner just swapped headers.

[isbluesmokebad?]

Acura EL's have that header. They are pretty much a copy of Honda Civic's.

Owner just swapped headers.

that's what came on the car new.

[green_hornet_96]

IIRC the cast mani disappeared off the y8 in '99.

Not much of a loss, the runners inside were rather small in comparison. Also '96-'98 samples o2 from runners 1-4, while the '99-'00 has the o2 by the cat to sample them all.

[Richie_A_19]

I've got one in the for sale section available. :TU: