p05 ecu

[BoogiepopJDM]

the p05 ecu redlines at 6,500rpm does that also mean that the fuel cut off is at 6,500rpm aswell, and will the tach bounce once i hit 6,500rpm, because i would really like to keep the cx p05 ecu for my dx head swap if the fuel tables continue past 6,5k and im allowed to rev a bit higher with the ecu.
can someone please educate me abit more before i send my ecu to be chipped for minor mods.

also i thought i read some where that almost all 92-95 ecu have the same fuel table including p28.

[BoogiepopJDM]

bump please help

[csaddict]

SO you think by changing your head that your ecu will remap? No. You just need to chip it and then you can load the stock map on and increase your rev limit. Chip kits are like $20 and take about an hour or less to solder in.

[BoogiepopJDM]

SO you think by changing your head that your ecu will remap? No. You just need to chip it and then you can load the stock map on and increase your rev limit. Chip kits are like $20 and take about an hour or less to solder in.

no i dont think that, i was asking if fuel cut off was at redline on any ecu and if the needle bounes at redline, i think it does. i think i found some guys here locally that will do it.