PDA

View Full Version : Manifold

popoff
11-08-2006, 09:45 AM
does eny D-series exhaustmanifold fit zc engine ? its the last crx 90-91mod zc (D16Z5 europ vers) same as D16a8,a9.. THANKS
hondajosh
11-08-2006, 09:54 AM
no zc IM bolt pattern is different
popoff
11-08-2006, 01:25 PM
okey, so I need too find an zc turbo manifold ? do you know of any?
CrazyConscious
11-08-2006, 01:44 PM
okey, so I need too find an zc turbo manifold ? do you know of any?

I think the exhaust ports are the same...but i'm not positive.
ryan89crx
11-08-2006, 04:30 PM
IM are different, exhaust are the same. should have been specified originally...

buy any D series turbo manifold, it will work
popoff
11-09-2006, 06:26 AM
IM are different, exhaust are the same. should have been specified originally...

buy any D series turbo manifold, it will workok so d-series manifolds will fit on the enginblokk...?
popoff
11-09-2006, 06:29 AM
IM are different, exhaust are the same. should have been specified originally...

buy any D series turbo manifold, it will worksorry my misstake... exhaust manifold im wondering about. THANKS
Clutchmaster
11-09-2006, 06:30 AM
no zc IM bolt pattern is different

he said exhaust brotha
popoff
11-09-2006, 06:46 AM
he said exhaust brothahehe I know , just telling im sorry for not understanding IM,EM but now I do ...
ryan89crx
11-09-2006, 07:18 AM
hehe I know , just telling im sorry for not understanding IM,EM but now I do ...:TU: yup, exhaust manifolds are interchangeable
bluedragon436
11-09-2006, 07:40 AM
exhaust manifolds are interchangable, except that you need to take the exhaust gasket from the DOHC and lay it on the manifold to make sure that you don't need to do some boring on the top of the manifold. I know that most D series manifolds will need a little bit bored out to make the flow perfect, cause most manifolds have a smaller exhaust port than the DOHC ZC has.
popoff
11-09-2006, 09:45 AM
exhaust manifolds are interchangable, except that you need to take the exhaust gasket from the DOHC and lay it on the manifold to make sure that you don't need to do some boring on the top of the manifold. I know that most D series manifolds will need a little bit bored out to make the flow perfect, cause most manifolds have a smaller exhaust port than the DOHC ZC has.thanks ,most APPRECIATE;D
popoff
05-06-2007, 09:10 AM
some custum work needed on d serie to fit zc .. on the topp bolt. and t4 housing is to big to fit on ramhornmani (has to turn it the other way) downpipe was welded to wrong side..
buds302
05-06-2007, 11:33 AM
but my D series exhaust manifold wont fit.....:(
sk8bdr15
05-06-2007, 09:37 PM
I have a DOHC zc and I am using a D series SOHC flange all I did was place the DOHC ZC gasket on the flange marked the different bolt paterns grinded and vuala
http://www.redpepperracing.com/gallery/d/173433-2/header_flngmodded.JPG