rod bushing for b-series rods

[K2e2vin]

In the old LS rod swap how-to thread he states .749" for floating pin and .747" for pressfit. Wouldn't this be negligible since the pin is held by the piston anyways?

[inh]

bi because a floating pin setup the pin is held in the piston with retaingin clips and the rod slides on the wrist pin. normal setups press the pin in tho the rod and the piston slides on the pin.

just get gx pistons, 21mm wrist pin :D

p.s. whats the link to that thread?

[K2e2vin]

http://www.d-series.org/forums/showthread.php?t=15600

engine is a d15b, so PDN pistons are a no go