d16a8 with pg7 ecu code

[nstereo2002]

:cool: ok just swapped my stock crx si motor with a teggy d16a8...this has the rover cover on it...so...i got it started last night and the ecu had a code on it...it is code 9 which is something to do with a cyp cylinder sensor can anyone tell me what this is??????

[tallkyle]

either a bad ground or you have the crank angle wires mixed up.

[nstereo2002]

either a bad ground or you have the crank angle wires mixed up.


crank angle??? is that the sensor on the front cam infront of the dizzy? i do not know which way they go so i guessed, my stock si wires are a blue w/yellow and blue w/white. in the d16a8 sensor plug i pulled the pins out and found a bluew/white or it may be yellow not sure since the colors have faded but the other wire is solid blue...any thoughts??

[tallkyle]

crank angle??? is that the sensor on the front cam infront of the dizzy? i do not know which way they go so i guessed, my stock si wires are a blue w/yellow and blue w/white. in the d16a8 sensor plug i pulled the pins out and found a bluew/white or it may be yellow not sure since the colors have faded but the other wire is solid blue...any thoughts??


uhh yea switch those 2 wires around and disconnect the battery for like 30 sec. then Try and start it back up. If you still throw a code put them back and check all your grounds. I had code 9 before and it turned out to be a loose valve cover ground

[nstereo2002]

:TU: cool thanks...i will try!! i was going to ask about how to re-set the ecu too but you answered that...thanx!!!!