y8 head question

[94lxcivic]

i have an offer to get a y8 head, but my car is obd-1. (94 lx sedan) what do i need to make all the sensors in the head obd-1? or retro fit it someway somehow?

[inh]

as far as i know, the head will bolt right on with no problems

[94lxcivic]

i know the bolt on isnt a problem... its the electronics..... like the vtec solenoid... is there a difference?

[grey89si]

None of the sensors in the head are different, only issue I encountered on my car (89 CRX Si, 99 EX longblock, OBD0-OBD1 conversion) was the intake air temp sensor on the Y8 manifold. Ive heard of 2 ways of solving this problem, one is using the Z6 or an A6 intake air temp sensor(same part, and both manifold mounted) and tap the sensor into the position where the Y8 version is located on the intake, if you use the Y8 manifold.

Other way is to use the Y8 sensor and locate into the intake in a similar fashion, or so Ive been told... Im currently running the Z6 version and havent had any issues, but supposedly both sensors plug in the same way:???:

[94lxcivic]

would my b7 iat sensor work?

[94lxcivic]

bump