D16y1/D16z6 HEAD !! READ

[Lyle_57IAL]

Hey guys, just today got my hands on a complete D16y1 Motor, which i will be useing the head for a mini me conversion on my y4. Now When takeing the head off do i have to undo the head bolts in a specific sequence ? or is that just for putting the head on?

If not What is the sequence that i have to remove the head studs in ?


ps. i am located in australia if that makes any difference

[honda tech]

what is a y4 and i dont think there is such a thing as a y1 either

[Lyle_57IAL]

yes in australia the d16y1 is the same as the d16z6

[civic97]

what is a y4 and i dont think there is such a thing as a y1 either

look where he is from. it has to be a motor that isnt availble here.

[bermanator]

hmmm so the y1 is like the Z6? Y* block with Z6 head/internals?
give some specs on this motor.

[bermanator]

and to answer your question just remove them in order if you're worried although it shouldnt matter. just make sure its even when you put it back on.

[Lyle_57IAL]

The D16y6 is identical with the D16z6 us spec, i am unsure of the order this has to be done, does anyone know the order?

[civic97]

9 3 1 5 7
8 6 2 4 10

thats the install process hope that helps

[Lyle_57IAL]

unreal mate, in what way are the bolts actually numbered thuogh? if your looking at the engine from head on with the exhaust manifold at the front and intake at the rear

[civic97]

unreal mate, in what way are the bolts actually numbered thuogh? if your looking at the engine from head on with the exhaust manifold at the front and intake at the rear

yes exhaust at front

[Lyle_57IAL]

9 3 1 5 7
8 6 2 4 10

thats the install process hope that helps



Also is that the sequence to do up the bolts? or un do the bolts?

[civic97]

to do up lol. when you install them you need to torque them in three seprate steps.