d15b

[civic510z]

my d15b came in today and i got the p08 with it :mrgreen: .i am using a 92 dx engine harness. i did alot of reseach and found out that the d15b use 1 wire o2 and do not need a oil pressure senor to run vtecMy question is how do i run the 02 to the ecu and what pin dose it go to? and do i just run a wire from the vtec to pin 4 and that all ? i can into a little problem. the exhaust manfold have a two cut bolt which soupose to connect to the cat. how am i soupose to get the bolts off?

[Exempt]

For O2, I believe u splice into D14, which should be the O2 signal wire (on the P28 it is)... And splice the new O2 connector onto the other end of the wire (on the exhaust manifold end)...

Check here for a pinout to see which pin is D14...
http://www.hondaswap.com/forums/index.php?showtopic=29360

In all actuallity, if your current O2 works, you can just swap them out, and the P08 will run it just fine... Might be easier... Wouldnt have to mess with the wiring...

And if u dont have a green connector on your VTEC solenoid, then u are correct dont need the pressure switch... I have seen some D15Bs that did have the VPS... Mine didnt have it tho... Since I was using the P28 I had to buy one (or rig it but didnt want too)... If you do have one, I suggest using it... As for VTEC, yes, just run a wire from A4 to the single wire on the solenoid... :TU:

[civicracer94]

my d15b came in today and i got the p08 with it :mrgreen: .i am using a 92 dx engine harness. i did alot of reseach and found out that the d15b use 1 wire o2 and do not need a oil pressure senor to run vtecMy question is how do i run the 02 to the ecu and what pin dose it go to? and do i just run a wire from the vtec to pin 4 and that all ? i can into a little problem. the exhaust manfold have a two cut bolt which soupose to connect to the cat. how am i soupose to get the bolts off? you can just use a 4 wire o2 sensor with the dx harness its a plug and play deal even with a p08 and some d15b's you will have to wire your vtec oil pressure sensor what yr is your car ? if you have a 92 you will not have to pin the ecu for vtec cuzz all 92's are prewired for vtec you will just have to run it to passenger side harness plug some one help me out on what color they are

[civic510z]

in oneconnector there is a single green wire and another conector there is two wire a blue with black and a all black one. My car is a 92 and it is wire for v-tec. I just having a hard time finding what wires are use at the connect on the right side spring tower. anyone know plz help out

thanks very much!!!