CG Tranny (from 86-89 JDM Integra)

[Anonymous]

I have an 86-89 ZC out of an Integra (not CRX), and it has a CG Tranny on it. I need to weld mounts, but I can't figure out where the stock mounts went on the CG Integra Tranny. Any help would be great!

Thanks,
--Josh

[strudel]

I have no idea what a CG tranny is but USDM 86-89 tegs have the transmission mount attached to the 3 bolt holes on the front of the tranny.

[-TJ]

The CG tranny is also found on the US 86-89 Integra. The mounts go on the front (3 M10 bolts?) and on the opposite corner in the back. There is a specially cast piece that goes between the tranny & another mount piece before the whole mount assembly gets to the rubber part on the x-member. If you want a picture of what I'm talking about, I just happened to have pulled my D16A1 2 days ago. E-mail if you want.

Unless you are using this tranny in a 84-87 Civic/CRX or an 86-89 Integra, you'd be FAR better off using an L3 or S20 tranny, depending on the chassis you have.