Transmission Bolts [Archive]

shorty_du_op

11-10-2003, 10:44 AM

I'm not sure if this is the right place to post this, but I'm looking for what size bolts hold the transmission to the block.

Also, what bolts should I use to hold the block on an engine stand? I'm assuming the same thread type as what I asked above correct?

Honda4VW

11-10-2003, 10:54 AM

I'm not sure of the size right now. Ill check later in my Helms for the size needed.

When I got an engine stand to put my block on, I found that I copuld not find a bolt long enough to fit the mounting point on the stand. The longest bolt I could find in the desired thread was from napa. I think it was 3-1/2"-4" long. I ended up having to cut the mounting points on the stand a little bit to allow the bolt to thead into the block. Most likely youll have to do something similar. Just something to keep in mind.

shorty_du_op

11-10-2003, 11:32 AM

I can get bolts up to about 6.5" in length so that isn't a problem... I just need the thread size.

shorty_du_op

11-11-2003, 10:45 AM

Can anybody check on this for me real quick please. I'd really appreciate it!

TurboHatch95

11-12-2003, 05:44 AM

12 x 1.25mm
60 Nm (6.0Kg-m, 43 Lb-Ft)

shorty_du_op

11-12-2003, 09:08 AM

:D THANK YOU!

TurboHatch95

11-12-2003, 01:21 PM

no prob