PDA

View Full Version : o2 housing/downpipe

Sonny7730
08-14-2004, 12:12 PM
i found this on ebay, and I'm wondering if it would work for my t-25....? otherwise, i'm about at a loss as what to do for that end of my turbo set up. could I do just a downpipe right from the turbo? or do I have to have the o2 housing? and if I don't need the o2 housing, where the heck do I find the flange so that I can have one made? Please any suggestions would be greatly greatly welcome!

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7915961536&fromMakeTrack=true

thanks!

p.s. also, where did you guys get your gaskets from? i've been searching around, and found a lot of confusing stuff as to what i need.....
pitchblacktyper
08-14-2004, 12:27 PM
what manifold are you using on the turbo set up? that downpipe would work fine, but if you had like a cx mani with the o2 on top, you could run the o2 there, get a flange and get a custom down pipe made. if you get that downpipe that you listed you are just gonna have to cut it anyways...
Sonny7730
08-14-2004, 01:04 PM
actually, the manifold that i'm going to be using does not have an 02 bung. where would i have to cut this one?
bigwig
08-14-2004, 01:05 PM
That is WAY over priced.

just go on apturbo and buy a flange for your T25 and have a welder do the rest. $125 for a mandrel 3" bend on a flange is ridiculous

also gaskets are over rated. if the two surfaces are very flat and similar materials then you dont really need a gasket. you can buy some liquid copper gasket for extra security
pitchblacktyper
08-14-2004, 01:05 PM
cut it right after the o2 bung so you could use it and then just get the exhaust shop to fab it to mate you your exhaust piping.. you should be set. sucks that you have to spend money on that nice downpipe and then cut it though.,
Sonny7730
08-14-2004, 01:47 PM
is it just apturbo.com?
Sonny7730
08-15-2004, 08:47 PM
hey bigwig, is it just apturbo.com, or is it something else?
bigwig
08-15-2004, 10:28 PM
www.atpturbo.com sorry :(
Sonny7730
08-16-2004, 09:04 AM
it's all good. i REALLY appreciate it, cause that seriously helps me out tons. now I can just get a downpipe fabbed up and not have to worry about stupid o2 housing and all that crap! thanks again man!